Apply thermal dissipation to two capacitors in an electronics enclosure model

00:03

To prepare for running an electronics enclosure simulation in Autodesk CFD, you must first specify the physical characteristics of the model.

00:13

This includes defining boundary conditions, such as applying a heat dissipation (in the form of a volumetric heat generation)

00:20

to the two capacitors on a PCB.

00:23

Begin with Boundary Conditions selected on the Setup tab of the ribbon.

00:27

Capacitors are modeled as parts, so you also need to change the selection mode to Volume on the Selection panel.

00:35

If needed, hide the exterior casing and air parts so you can access the internal components.

00:41

Press CTRL while middle-clicking both the casing and the air part to hide them.

00:46

Left-click to select the two capacitors.

00:49

Next, on the Setup tab, Boundary Conditions context panel, click Edit.

00:56

In the Boundary Conditions quick edit dialog, under Property settings, verify that the Type is set to Total Heat Generation.

01:04

Set the Unit to W for Watts, then set the Total Heat Generation to 4.

01:10

Click Apply.

01:12

To verify that the heat condition is applied properly to the two capacitors, check the Design Study Bar.

01:19

Then, in the graphics window,

01:21

ensure that the color of the stripes on the capacitors now matches the Total Heat Generation color in the legend.

01:28

With the heat dissipated by the capacitors properly set, the next step is to do the same for the transformer.