Design a model for 3D printing

The challenge: Create a micro drone chassis under within a 4in cube and under 12g mass.

Complete the required objectives:

• Review a sample design.
• Create a micro drone chassis, camera mount and landing gear.
• Inspect the mass properties of the drone.
• Refine and validate a design.

Note: This micro drone is a sub-class of drones that is intended to be flown indoors. The total drone weight including all components and 3D printed parts ranges from 40-50g. The FAA requires that any drones flown in federally regulated airspace, above the weight of 250 grams (0.55lbs) and flow for recreation or commercial applications must register their drone and take a free online safety test to remain in compliance. If you build and fly your micro drone inside or within the confines of a drone specific safety cage, this is outside of federally regulated airspace and a drone license and registration should not be required. As a safety precaution you should check your local regulations to ensure there are no additional guidelines that must be followed.