Module

30 min.

Working in tight spaces with duct and pipe in Revit

Module overview

Using the Revit Interference Check tool, we can find clashes and fix them by running parallel pipes and connecting fittings to each other.

This module takes approximately 30 minutes to complete. By the end of the module, you should be able to:

  • Work with Interference Checking
  • Create and modify parallel pipes
  • Change short runs of ducts so fitting connects to fitting

Before you start

  • Please make sure you have the Revit software loaded.
  • If you have technical difficulties, please reach out to product support. 

Module downloads

These downloadable resources will be used to complete units in this module:

Module outline