Practice exercise

00:01

This is a practice exercise video solution

00:05

for this practice.

00:06

Let's get started with the design standard drawing views,

00:09

dash practice dot F three D.

00:11

We're going to go to the design workspace picker

00:14

start and create a new detailed drawing from design

00:17

and in this case we're going to use the standard units

00:20

of inch and the sheet size of B and say okay,

00:25

We want to begin by changing our scale.

00:27

This is going to be a 1-1 drawing view showing only visible edges.

00:31

We're going to be using a third angle projection.

00:33

So I'll place the front view down here in the lower left hand corner of our drawing.

00:38

Then we're going to select create projected view and create our top right

00:43

and our isometric views and click the green check mark.

00:48

Next we want to create a section view So we'll need to select the parent

00:51

view and place our section line using

00:53

the green triangles as our midpoint references.

00:56

We'll select the green check mark again

00:58

and we're going to go ahead and place this here and say okay

01:02

noting that the note is off of our drawing sheet.

01:04

We might need to reposition some of our views So let's

01:06

go ahead and move our views up a little bit.

01:08

Moving the isometric view

01:10

and moving our section view up as well

01:14

to make sure that everything is visible.

01:16

You can play around with adding additional view types.

01:19

But at this point let's make sure that we do save this and we don't lose any work