Module quiz

5 questions

Which selection is needed for a bore toolpath?

(Select one)
Select an answer

What is a potential issue with using 2D Contour toolpaths on complex geometry?

(Select one)
Select an answer

What information can only be validated by machining a part?

(Select one)
Select an answer

With the WCS set on the top of a vise, the Bottom Height set at the same location and an Adaptive toolpath with .05 Radial stock to leave and .02 Axial stock to leave, what is the final Z height of the toolpath?

(Select one)
Select an answer

Which toolpath geometry option allows a 3D Adaptive Clearing toolpath to calculate remaining stock to be machined and avoid “air cutting” where stock has already been removed?

(Select one)
Select an answer

5/5 questions left unanswered

Was this information helpful?