Machine elements design in mechanical engineering - Quiz

Machine elements design in mechanical engineering - Quiz

Required for course completion

16 questions

What four panels are included on the Design tab of the Assembly environment?

(Select one)
Select an answer

The Frame Generator tool only uses cross sectional shapes from the Content Center.

(Select one)
Select an answer

What are the two Hole Depth types in the Bolt Connection Generator?

(Select one)
Select an answer

The Inventor Content Center must be installed and configured for the Bolt Connection Generator to work.

(Select one)
Select an answer

What four placement options are available in the Bolt Connection Generator?

(Select one)
Select an answer

The Bolt Connection Generator only creates bolts, washers, and nuts. The holes must be created in the part environment.

(Select one)
Select an answer

Which of these is not one of the Bolt Connection Generator Calculators?

(Select one)
Select an answer

You can't override the material being used for the strength calculation.

(Select one)
Select an answer

What types of geometry can be used to place frame members?

(Select one)
Select an answer

The Frame Generator tool eliminates the need for constraints between frame members.

(Select one)
Select an answer

How many different ways can the frame member be positioned relative to the input geometry?

(Select one)
Select an answer

What is the default material selected for all Frame Members?

(Select one)
Select an answer

What end treatment tool will extend one frame members and trim the other to meet it at a 90 degree angle?

(Select one)
Select an answer

Only one frame member can be selected at a time while using the Trim/Extend tool.

(Select one)
Select an answer

What are the four types of Spring component generators?

(Select one)
Select an answer

What two inputs are required for placement of compression springs?

(Select one)
Select an answer

16/16 questions left unanswered

Was this information helpful?