Levels in Revit for structure

00:03

Levels are finite horizontal planes that act as a reference for level-hosted elements, such as roofs, floors, and ceilings.

00:11

In Revit, you use the level tool to define a vertical height or story within a building.

00:17

More specifically, levels define the floor levels of your building or other important datums like the top of a wall,

00:24

the bottom of the foundation, or the roof plate height.

00:27

To place a single level or multiple levels in Revit, first, open an elevation or section view.

00:33

Then, on the Structure ribbon, in the Datum panel, click Level.

00:37

Note that the Level option is only available when an elevation or section view is open.

00:42

With the Level tool selected, click in the drawing area to define the first end, or the head, of the level.

00:49

Drag the cursor horizontally, and then click in the drawing area again to define the second end of the level, also known as the tail.

00:57

Click Modify to end the command.

00:60

Once the level is created, select it to open the Properties palette, where you can adjust its Elevation and Name.

01:07

There are a few quick tips that can make working with Revit levels easier.

01:11

Number one, to change the length of a level, first select it.

01:15

At the end of the line near the bubble, click the open dot control, and then drag to adjust the length.

01:21

Keep in mind that any level lines locked into alignment adjust in length together.

01:27

If you want to move a level line individually, click the locked padlock icon to unlock that alignment first.

01:34

Another tip: for better readability of labels and elevations when lines are close together,

01:39

add an elbow, or offset, to relocate the level head.

01:43

Select the level you want to modify, and then click the Add Elbow drag control, which looks like the letter Z.

01:50

Drag the two open dot controls to adjust the position of the elbow.

01:54

Keep in mind that this is a 2D override to the level, so it will only appear in the view used to make the change.

02:02

One final tip is that you can display level changes in similar parallel views for more consistency.

02:08

To do this, first select the levels with the 2D changes that you want to make visible in other views.

02:14

Then, on the ribbon, click Propagate Extents.

02:18

In the Propagate Datum Extents dialog, select the views you want to apply the 2D overrides to.

02:24

Click OK and save the file.

02:27

You now know how to quickly and efficiently place levels within your Revit design model.