Wall layouts - create straight and curved walls

Step-by-step guide

Draw straight and curved walls. Create similar walls. Apply alignment constraints to walls.

1. In Revit, begin a project using the default.rte template.
2. In the Architecture tab, Build panel, expand Wall and select Wall: Architectural.
3. In the Properties palette, Type selector, select Exterior – CMU on Mtl.Stud.

4. Pick a point on the screen, drag to draw the wall to the right 10'-0", and click the endpoint to change directions.
5. Draw a wall down 7'-0", and back to the right 8'-0".
6. Drag up until you see the alignment line and snap, and pick that point.

7. Continue drawing walls by typing in the distance 10 feet to the right, and then 20 feet down.
8. Draw a few more walls 14'-0" to the left, 8'-0" down, and a final wall of 14'-0" in alignment with the beginning of the first wall.

9. Press ESC twice to end the Wall command.
10. Select the vertical wall on the right, and drag it out to 13'-6".
11. Drag the lower vertical wall to the right until it aligns with the vertical wall above, and click to place it.
12. Click the padlock icon to constrain the walls together.

13. Drag the other wall to see that the aligned and locked wall moves with it.
14. Remove the alignment constraint to move the walls independently again.

To create a curved wall:

15. Select one of the walls, then right-click and select Create Similar.
16. In the Draw panel, select Start-End-Radius Arc.
17. To define the start and end points, click the end of the lower horizontal wall, and the end of the upper horizontal wall.

18. To create the curve, drag to the left where it shows the tangent alignment.

19. In the ribbon, click Modify to end the command.